Installation

Supplies: Electrical Tester ,Pliers, Four crimp connectors

Directions:

1. Locate your central wire harness.  This wire harness is usually located near the rear on sport bikes and on either side below the seat on cruiser motorcycles .

2. The adaptor that will affix to the motorcycle has five wires total.  Four wires which are labeled run light, brake light, left & right signals  and one black wire, which is the neutral or ground wire.

3. Connect your US signaling apparel and the adaptor provided together.

4.  Installing without a test light just fasten the black wire under any metal bolt temporarily to complete a proper electrical ground.

5.You can also use an electrical tester to find which wires on your motorcycle represents the brake light, running light, and indicator lights. 

6. Turn your motorcycle key to the ON position, for testing purposes only.

7. Once these wires are identified on your motorcycle harness they should be matched with the corresponding wires that are labeled on the US apparel adaptor or just look at the  apparel lights and the motorcycle signal lights which will display simultaneously .

8. After this process we suggest that the adaptor’s black ground wire be attached to the motorcycles wire harness also.

10. Tie off the motorcycle adaptor to desired length on either side of bike.

11. Turn your motorcycle key to the ON position connect you apparel become one with the machine.